Back to dashboard

ActiveCampaign: set up your sending domain

What this guide is for

By default, ActiveCampaign signs your emails with its own domain (e.g. acems1.com). When you set up a sending domain, the DKIM signature uses your From domain, which enables DMARC alignment.

Expected records

Manual setup requires four DNS records, shown in a table by ActiveCampaign. Among them:

Type Name (host) Value
CNAME acdkim1._domainkey value provided by ActiveCampaign
CNAME acdkim2._domainkey value provided by ActiveCampaign
TXT (DMARC) _dmarc basic DMARC record created by the procedure, or yours if one already exists
  • Copy the type, name and value of each row exactly as shown. The short name (acdkim1._domainkey) is the most common; the full name (acdkim1._domainkey.example.com) is only needed if your host does not append the domain automatically.
  • TTL: your host's default value, or 300 seconds if there is none.
  • Since February 2023, ActiveCampaign publishes DKIM as CNAME. An older TXT setup (dk selector) still works, but CNAME is recommended.
  • SPF: with a Mailserver Domain set up as a CNAME, ActiveCampaign handles SPF and you do not need to change your root domain's SPF record. Older setups used include:emsd1.com.

Steps in ActiveCampaign

  1. Click Settings (gear icon), then Advanced.
  2. In the Sending Domain section, choose Configure Domain (automatic record creation with supported hosts) or Set up manually.
  3. Enter the domain of your From address, without https:// (for [email protected], enter example.com).
  4. Verify the domain: ActiveCampaign sends a verification link to an address on that domain.
  5. Click Set up DNS records and create each record in the table at your DNS host.
  6. Return to Advanced Settings, open the menu to the right of the domain and choose Recheck Authentication. Propagation is usually fast, but can take up to 24 hours.

The message "Only one of your CNAME records is set up" means one of the two DKIM CNAME records is missing or contains a typo.

Check the setup

  1. In Advanced Settings, the status should be Authenticated (green indicator).
  2. Send a test email to Gmail and check for DKIM: PASS with your domain.
  3. Run a new scan in this tool: the acdkim1 and acdkim2 selectors are recognized if present.

DMARC

Publish a single TXT record at _dmarc.<your domain>, starting with monitoring:

v=DMARC1; p=none; rua=mailto:[email protected]

A quarantine or reject policy requires ActiveCampaign DKIM to be set up, otherwise all your ActiveCampaign mail fails DMARC. Move there gradually, after reading the reports.

Official documentation

ActiveCampaign: setup guide - SEKOIA